Full Body System: Change a Lamp Socket

Tools required

• 3/8-drive Ratchet
• T27 Torx Bit
• Pop Rivets
• Large Paper Clip

Procedure

IMPORTANT: Always Disconnect Power from the System when Servicing.

1. There are metal socket strips pop riveted at the top and the bottom of the inside reflectors. The cover to the unit half to be repaired must be removed. Refer to Remove the Cover of an Ultralite Full Body System procedures.
2. There will be two wires connected to the back of the lamp socket. These wires can be released by inserting a large straightened paper clip and carefully pulling the wire away from the socket.
3. Gently pull the socket strip away from the inside reflector and slide the defective socket off of the strip.
4. Slide the new lamp socket on the strip and insert wires to the back.
5. Place the strip against the inside reflector and pop rivet.
6. Replace all lamps.
7. Connect the unit to the power source.

If you need assistance, please contact us.