Hand-Foot System: Change a #9160 Ballast

Tools required

• None

Procedure

1. UNLOCK WITH PASSWORD "2634" and SEL appears press the select code numbers.
2. SELECT CODE 255 Zero the NVR chip, takes a few minutes then SEL appears
3. This clears everything from memory chips so you must replace all information.
4. SELECT CODE 204 Set Serial Number________ put in your number.
5. Press enter twice so that PASS appears again.
6. UNLOCK WITH PASSWORD "2718"
7. SELECT CODE 107 Set Delay from start to lamp turn on_____ press 5, enter
8. SELECT CODE 106 Set Password (put your serial number)
9. SELECT CODE 104 Sets Max. time _____:_____(minutes:seconds) set at whatever you require.
10. SELECT CODE 101 RECALCULATE NVR CHECKSUM (This Select Code is what recalculates the NVR chip and is most important to in the correct order.)
11. PRESS 101 THEN ENTER, THEN PRESS CLEAR AND UNPLUG UNIT FROM WALL OR PLUG TO THE CONTROLLER FOR 10 TO 15 SECONDS, REPLUG AND HIT ENTER UNTIL PASS APPEARS AGAIN. It should now accept your password.

If you need assistance, please contact us.